Bravilor RLX 41 Table Top Coffee Machine

This RLX-series brews coffee into glass decanters and is simple to connect to the water mains.

The hot water or hot water/steam models complete this range and makes them suitable for buffets or similar serving requirements.

Delicious fresh coffee

Robust and quality appearance

Equipped with a "coffee-is-ready" signal and descale indicator

Coffee of consistent quality:

self-regulating hot plates

Bravilor Bonamat glass decanters maintain the quality of the coffee

User friendly and low maintenance

Technical Details	RLX 31	RLX 41	RLX 131
Throughput/hour coffee 230V	approx. 15 litres	approx. 15 litres	N/A
Throughput/hour coffee 400V	approx. 15 litres	approx. 15 litres	approx. 30 litres
Throughput/hour HW 230V	approx. 18 litres	approx. 25 litres	N/A
Throughput/hour HW 400V	approx. 18 litres	approx. 25 litres	approx. 18 litres
Brewing time 230V (approx.)	6 min. 1 decanter	6 min. 1 decanter	N/A
Brewing time 400V (approx.)	6 min. 1 decanter	6 min. 1 decanter	6 min. 2 decanter
Rated power 230V	2880W	2880W	N/A
Rated power 400V	3990W	4095W	6070W
Dimensions in mm (wxdxh)	475x509x448	475x509x448	705x509x448

*This machine will be installed by Bravilor
please make sure installation guidelines are followed

To ensure your installation is completed efficiently, please note Bravilors conditions for installation

The Site MUST:

Have the electrical supply within 1 meter of the centre line of the machnies proposed location.
Have the correct electrical supply for the ordered machine ready on site. E.g. single or three phase.
Have a 15mm copper pipe mains water supply terminating with shut off valve incorporating a 3/4 inch BSP connection within 1 meter of the machines centre line at the proposed location.
Have site water pressure within the operating range of 1 -10 bar. (15 - 150psi).
Ensure that if the counter or unit requires any holes drilling to enable the engineer to site the machine, these must be completed before the engineer arrives on site.
Ensure the machine is immediately available to the engineer, within reasonable distance of the installation site. (should this require any machine over 15kg lifting any distance greater than 1 meter assistance must be available)
Ensure the relevant product ingrediants are to hand

The engineer WILL:

Unpack the machine and inspect for transit damage.
Install the machine in its proposed location.
Connect power and water to the machine.
Commision the machine and function test to ensure it is operating to factory specifications.
Set the machine to any requirement the site may have - drink strength, cup size etc.
Train staff in maintenance, cleaning and operation.
Leave the area tidy, with the packaging flat-packed for the sites disposal.
Install Brita water warranty equipment were requested.

Bravilor DOES NOT authorise its service agents to:

Change the power supply cable already attached to the machine.
Connect the units to services over 1 meter away from the machines centre line. This is due to local authority bylaws, in most counties.
Modify the machines functions or programming to alter the machines designed manufactured purpose.
Any such changes without written consent from Bravilor Limited, would immediately invalidate the warranty.

View all products in Commercial Coffee Machines